SAP Coolant Pump SA


Coolant pump for industrial use, made in Europe

SKU: 6010 Category:


The SA pump is a motor-driven pump for machine tools. It is suitable for smaller, primarily semi-automatic and manual band saws as well as for circular saws and drilling machines, where no large quantities of coolant are required (see pumps PA-35 and PA-70). They are designed for industrial use and are characterized by their robustness and long service life. The SA type coolant pumps have the advantage that they can be operated on both single and three pasess without changes, as they are driven by a single-phase electric motor.

The SA is designed for industrial use and is characterized by its robustness and long service life and meets the requirements of IP 54 (learn how IP-codes correspond with NEMA).

The housing is made of extruded aluminum or non-flammable, acid-resistant plastic in accordance with the following standards: VDE 0730 and UL 94. The pump shaft is made of V-2A steel, the bearings are from NSK, extremely durable and vibration-damped, mounted in semi-rigid shells, which leads to an almost vibration-free operation.

The pump is resistant to liquids permeated with particles (e.g. contaminated coolant) and all chemical compounds that are typically used in cooling lubricants. It can be throttled up to 80%, which enables optimal adjustment of the flow rate. The inlet port of the pump is compatible with Quick-Fit couplings.

We can customize the SA for all mains voltages upon customer request.


Power Consumption: 0.08 HP (60 Watt)
Voltages: 220-240 VAC, 2Ph | 380 – 400 VAC, 2 PH
Phases: 2 Phases
Frequency: 60 Hz
Discharge Head: 14.1 feet
Capacity: 3.7 GPM (14 l/Min)
Immersion Depths: 3.3 in (85 mm) – 5.9 in (150 mm)
Cover Material: Extruded aluminium, POM
Impeller Material: POM
Shaft Material: stainless steel (AISI 303)
Bearings: CW long-life bearings in semi-rigid supports
Weight: 2.3 lb
Outlet Thread Ø: 3/8 ”
Protection Category: NEMA 3 (IP 54)
SKU: 6110


Discharge Head & Capacity

Figure 1 shows the maximum delivery rate depending on the discharge head for the pump SA.

Figure 2 shows the length of the immersion tube under “B”, which must be taken into account when ordering, see also Figure 3.


The pump is to be installed on the tank as shown in Figure 5 so that the immersion tube is immersed in the coolant. The housing part that contains the electric motor must not come into contact with the coolant. Ensure that there is adequate overflow in the tank.

 Electrical Connection

el connection SA pump

Additional information

Immersion Depth

3.3 in (85 mm), 4.7 in (120 mm), 5.9 in (150 mm), 7.1 in (180 mm), 7.9 in (200 mm), 9.8 in (250 mm), 11.8 in (300 mm)


220 – 240 / 380 – 400 VAC, 2 Ph, 480 / 575 VAC, 2 Ph